All modules, including the Laser and Impact Dot Peen, are controlled using the IMCNC mini CNC control software.
No, both the IMCNC Operating Software and Vectric software are only compatible with Windows systems.
No, both the Ez Carve and mini CNC control software are only compatible with Windows systems.
The software is provided on a USB drive, which you can install and register upon receiving the product.
Register on the Bravoprodigy official website and download the software from the member area after registration.
- Ensure UAC settings are at the “lowest” or “never notify” level.
- Verify correct installation, check power cord and USB connections, and make sure the emergency switch hasn't been pressed.
- If issues persist, restart the CNC software or try changing USB ports.
Confirm the computer's sleep/hibernate mode is turned off, verify you're using the correct software version, check power and USB connections, ensure the emergency switch hasn't been pressed, check for a blown fuse, and listen for any motor overcharging sounds.
